Setting up the server

Specify necessary information on each page of the Server Setup dialog box. When you finish, click the OK button. The Setup dialog box is displayed again.

To update Server settings, after you finish with the JP1/Software Distribution Manager setup, open Control Panel, choose Administrative Tools, and then choose Services to restart the Remote Install Server service.

The table below describes the Server setup items. If you have installed only Remote Installation Manager, the only pages that are displayed at setup are Database Environment, Communication, WSUS Linkage, and Audit Log.

Table 4-1 Server setup items

Classification	Item
Database Environment	Relational database settings (host name of database server, database name, administrator ID, and password)
Communication	Port numbers, startup protocol, interval transfer
Dial-up^#¹	Authentication (user name, password, and domain)
Server Customization	Number of subsystems that can be connected at one time
	Maximum number of subsystems in which jobs can execute concurrently
	When jobs will be deleted
	Monitor startup of subsystems
	Monitor file transfer errors of subsystems
	Accept suspended/resumed file transfer jobs from sources other than the connection destination
Multicast Distribution	Port numbers for multicast distribution and settings for sending jobs by multicast distribution (multicast address and packet size)
Log Options	Record the results of jobs
	Record the results of ID group jobs
	Record the results of all-lower-clients jobs
System Configuration	Apply system configuration information automatically
	Linkage when system configuration is changed
	Deletion history of system configuration information
ID Key for Operations	Select the node identification key
	Resolving IP addresses
	When resolution of IP address fails
	Use host IDs
Cluster Settings^#2	Enable the cluster system
HP OpenView Linkage^#3	Activate OpenView Linkage
	Host name or IP address and port number of HP NNM
	Update the system configuration of HP NNM
Event Service	Enable the event service
Error Handling	Generations of log file to be saved
	Maximum lines in a log file
	Type of Event Viewer message
Client Alert^#4	Relay client alert information to higher system
Client Alert^#4	Output of client alert information (to CSV file or Event Viewer)
Operation Monitoring	Saving operation monitoring logs
	Backing up operation histories
	Storing operating information in the JP1/Software Distribution relational database
	Timing of automatic storage of operating information in the JP1/Software Distribution relational database
	Outputting status of operation history storage in database
Network connection	Authentication information (login ID, password, domain name)
CSC Linkage	Deletion of Report message jobs that were executed from JP1/Client Security Control
WSUS Linkage^#5	Use of WSUS Linkage
Directory Linkage	Linkage with Active Directory
AIM	URL of Asset Information Manager Subset or JP1/Asset Information Manager to be connected
AMT Linkage^#6	AMT management user's user ID and password
Audit log	Output of audit logs

Y: Can be set. N: Cannot be set.

#1: This item is displayed when the remote access service is installed.

#2: This item is not displayed at relay managers.

#3: This item is displayed when OpenView Gateway Server has been installed.

#4: This item is available only on relay managers.

#5: This item is displayed only when the server's subcomponent Remote Installation Manager has been installed.

#6: This item is displayed if AMT Linkage has been installed.

All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.

4.2 Setting up the server