![[Contents]](FIGURE/CONTENT.GIF)
Job Management Partner 1/Software Distribution Setup Guide
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
These settings are for saving job execution results. You can save disk space if you disable the recording of unnecessary execution results. If the volume of recorded execution results for completed jobs becomes too large, operation of the Remote Installation Manager may slow down. You should therefore record only jobs with execution results that may require checking.
Figure 4-9 Log Options page
![[Figure]](FIGURE/MSE0070.GIF)
Select this check box to record in the Remote Installation Manager the execution results of jobs without an ID specification. The default is that this check box is selected. To record, you must also select the execution status of the job subject to recording.
For the following jobs, the execution status cannot be deleted automatically even after the job is completed:
Select this check box to record in the Remote Installation Manager for each client the execution results of jobs with an ID group specified. The default is that this check box is selected. When this check box is selected, you must select the execution status of the jobs that are to be recorded:
For clients that belong to an ID group managed by a relay system, this setting is enabled for all job types. For clients that belong to an ID group managed by the managing server, this setting is disabled for the following jobs, and all execution results information for such jobs is recorded in the managing server:
Select this check box to record in the Remote Installation Manager of the relay manager the execution results of all-lower-clients jobs that each client executes. The default is that this check box is selected. When this check box is selected, you must select the execution status of the jobs to be recorded.
All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.