Job Management Partner 1/Software Distribution Setup Guide
![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
![[Next]](FIGURE/AFTER.GIF)
If you use a network drive for the operation history storage directory or the operation history backup directory, you use this page to set authentication information for connecting to the network drive. If you set authentication information in the Network Connection Settings dialog box during installation, you can use this page to change that authentication information.
Figure 4-18 Network Connection page
![[Figure]](FIGURE/MSE0155.GIF)
- Login ID
- Specifies the login ID used to connect to the network drive, expressed as 1 to 30 alphanumeric characters and symbols. The following symbols cannot be used:
- \ / * : ; , + < = > ? | [ ]
- If you specify a network drive for the operation history storage directory and operation history backup directory, make sure that you also specify the password and domain name.
- Password
- Specifies the password used to connect to the network drive, expressed as 1 to 30 alphanumeric characters and symbols. Spaces cannot be specified.
- Domain name
- Specifies the domain name used to connect to the network drive, expressed as 1 to 127 alphanumeric characters and symbols. The following symbols cannot be used:
- \ / * : ; , + < = > ? | [ ]
All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.