9.1 List of commands
The following table lists and describes the commands used in HA Monitor.
Command name |
Description |
Executor |
||
---|---|---|---|---|
Superuser |
General user |
|||
Commands for configuring and changing the environment |
Specifies HA Monitor environment settings. |
Y |
N |
|
Detects IP addresses. |
Y |
N |
||
Checks definitions. |
Y |
Y |
||
Changes shared resources while the active server is running. |
Y |
N |
||
Changes settings while HA Monitor and servers are running. |
Y |
N |
||
HA Monitor operation commands |
Starts HA Monitor. |
Y |
Y |
|
Terminates HA Monitor. |
Y |
Y |
||
Connects HA Monitors manually. |
Y |
Y |
||
Server operation commands |
Starts a server in the monitor mode. |
Y |
Y |
|
Terminates the active server in the monitor mode. |
Y |
Y |
||
Terminates a standby server. |
Y |
N |
||
Starts a resource server. |
Y |
Y |
||
Terminates an active resource server. |
Y |
Y |
||
Terminates a standby resource server. |
Y |
N |
||
Starts a server in the wait state as the active server. |
Y |
N |
||
Terminates a server in the wait state. |
Y |
N |
||
Status checking commands |
Displays the status of servers and hosts. |
Y |
Y |
|
Displays the status of the reset path. |
Y |
N |
||
Displays the status of monitoring paths. |
Y |
N |
||
Displays the server switchover order control status. |
Y |
Y |
||
Command for performing hot standby processing |
Performs planned hot-standby switchover or forced hot-standby switchover. |
Y |
N |
|
Command issued from within user commands |
Specifies server information in the active system that is to be inherited, or references and displays inherited server information in the standby system. |
Y |
Y |
|
Command for collecting troubleshooting information |
Collects HA Monitor troubleshooting information. |
Y |
N |
|
Command for manipulating shared resources |
Releases reservations for shared disks. |
Y |
N |
- Legend:
-
Y: Can execute
N: Cannot execute