For Linux(R) (x86) Systems HA Monitor Cluster Software
Contents
Glossary
Index
Previous
314 / 376
Next
Cover
9. Commands
This chapter explains the commands used in HA Monitor.
9.1 List of commands
9.2 Headings used in the explanations of commands
9.3 Syntax symbols
9.4 monact (starts a server in the wait state as the active server)
9.5 monbegin (starts a server in the monitor mode)
9.6 monchange (changes settings and operations while HA Monitor and servers are running)
9.7 moncheck (checks definitions)
9.8 mondeact (terminates a server in the wait state)
9.9 mondevice (changes shared resources while the active server is running)
9.10 monend (terminates servers in the monitor mode)
9.11 moninfo (specifies server information in the active system that is to be inherited, or references and displays inherited server information in the standby system)
9.12 monlink (connects HA Monitors manually)
9.13 monlistip (detects IP addresses)
9.14 monodrshw (displays the server order control status)
9.15 monpath (displays the status of monitoring paths)
9.16 monresbgn (starts a resource server)
9.17 monresend (terminates an active resource server)
9.18 monressbystp (terminates a standby resource server)
9.19 monrp (displays the status of the reset path)
9.20 monsbystp (terminates a standby server)
9.21 monscsiclr (releases reservations for shared disks)
9.22 monsetup (specifies HA Monitor environment settings)
9.23 monshow (displays the status of servers and hosts)
9.24 monstart (starts HA Monitor)
9.25 monstop (terminates HA Monitor)
9.26 monswap (performs server hot-standby switchover)
9.27 monts (collects HA Monitor troubleshooting information)
To Page Top