Hitachi

JP1 Version 12 JP1/Automatic Operation Configuration Guide 


5.4 Installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)

To set up a cluster system, you must install JP1/AO on both the active server and standby server.

To install JP1/AO, perform the procedure described below.

Table 5‒4: Procedure for installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)

Task

Required/optional

Reference

1

Perform the tasks that must be completed in advance.

Required

5.4.1 Tasks required before installation of JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)

2

Configure services before installation (if Common Component is already installed).

Required

5.4.2 Procedure for configuring services before installation (if Common Component is already installed)

3

Install JP1/AO on the active and standby servers (if Common Component is already installed).

Required

5.4.3 Procedures for installing JP1/AO on the active server and standby server (if Common Component is already installed)

4

Set up the active server (if Common Component is already installed).

Required

5.4.4 Procedure for setting up the active server (if Common Component is already installed)

5

Set up the standby server (if Common Component is already installed).

Required

5.4.5 Procedure for setting up the standby server (if Common Component is already installed)

6

Register services by using the cluster software (if Common Component is already installed).

Required

5.4.6 Procedure to register services by using the cluster software (if Common Component is already installed)

Organization of this section