5.4.3 Procedures for installing JP1/AO on the active server and standby server (if Common Component is already installed)

To install JP1/AO on the active server and standby server:

1. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the active server.

2. Install JP1/AO on the active server.

   • Specify a path on a shared disk for the location of the database.

   • Specify the logical host name for the JP1/AO server host name.

   • For the JP1/AO installation destination, specify the same drive and folder names in the active server and standby server.

   After installation, if a message is displayed indicating that a restart is required, restart the active server.

3. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the standby server.

4. Install JP1/AO on the standby server.

   • Specify a path on a shared disk for the location of the database.

   • Specify the logical host name for the JP1/AO server host name.

   • For the JP1/AO installation destination, specify the same drive and folder names in the active server and standby server.

   After installation, if a message is displayed indicating that a restart is required, restart the active server.