5.4.2 Procedure for configuring services before installation (if Common Component is already installed)

Before you install JP1/AO in a cluster system, you must configure services.

To configure services before installation:

Make sure that JP1/AO or any conflicting product is not installed on either the active or standby servers.

If it is installed, uninstall JP1/AO or conflicting product.
Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the active server.
Use the cluster software to bring the above resource group online.
Use the cluster software to bring the Hitachi Command Suite services other than HiRDB/ClusterService _HD1 offline.
On the active server, execute the hcmds64srv command with the /stop option specified to stop the JP1/AO service.
Use the cluster software to bring the HiRDB/ClusterService _HD1 service offline.
Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the standby server.
Use the cluster software to bring the above resource group online.
Use the cluster software to bring the Hitachi Command Suite services other than HiRDB/ClusterService _HD1 offline.
On the standby server, execute the hcmds64srv command with the /stop option specified to stop the JP1/AO service.
Use the cluster software to bring the HiRDB/ClusterService _HD1 service offline.
In the cluster software, suppress failover for the resource group where the Hitachi Command Suite products are registered.

Right-click a service in the cluster software, and then select Properties and then Policies. Then specify the settings so that a restart does not occur if the resource fails. Perform this action for all services registered in the resource group in order to suppress failover.