5. Setting up a cluster system

This chapter describes how to set up a JP1/AO cluster system.

Organization of this chapter

• 5.1 Procedure for installing JP1/AO in a cluster system

• 5.2 Installation prerequisites (for cluster systems)

• 5.3 Installing JP1/AO in a cluster system

• 5.4 Installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)

• 5.5 Cluster settings file (cluster.conf)

• 5.6 Folders created on the JP1/AO shared disk

• 5.7 Cluster service control commands to be registered in the cluster software

To Page Top