5.3 Installing JP1/AO in a cluster system

To set up a cluster system, you must install JP1/AO on both the active server and standby server.

When you set up JP1/AO in a cluster system, it also sets up Common Component, which is used by Hitachi Command Suite products.

To install JP1/AO, perform the procedure described below.

Table 5‒3: Procedure for installing JP1/AO in a cluster system
Task		Required/optional	Reference
1	Perform the tasks that must be completed in advance.	Required	5.3.1 Tasks required before installation of JP1/AO in a cluster system
2	Create a resource group by using the cluster software.	Required	5.3.2 Procedure for creating a resource group by using the cluster software
3	Install JP1/AO on the active server and standby server.	Required	5.3.3 Procedures for installing JP1/AO on the active server and standby server
4	Set up the active server.	Required	5.3.4 Procedure for setting up the active server
5	Set up the standby server.	Required	5.3.5 Procedure for setting up the standby server
6	If the OS is Windows, register services in the cluster software.	Required	5.3.6 Procedure for using the cluster software to register services (in Windows)
6	If the OS is Linux, register services and configure a resource group in the cluster software.	Required	5.3.7 Procedure for using the cluster software to register resources and to set up the resource group (in Linux)

Organization of this section