5.3.7 Procedure for using the cluster software to register resources and to set up the resource group (in Linux)

Use the cluster software to register resources and specify the settings for starting the resource group, stopping the resource group, and monitoring resources.

For details about the registration and setup procedures, see the documentation for the cluster software.

To register resources and configure the resource group by using the cluster software:

Use the cluster software to move the ownership of the resource group to the active server.
Use the cluster software to bring the resource group offline.
Use the cluster software to register resources.
Specify the settings such as those for starting the resource group, stopping the resource group, and monitoring resources.

When specifying these settings, apply the following resource dependency:

If the resource group is online, the resources listed below (a to f) must start in the order from a to f. If the resource group is offline, the resources must start in the order from f to a.

For details about the commands that are to be registered in the cluster software to start, stop, monitor, and kill resources, see 5.7 Cluster service control commands to be registered in the cluster software.
1. IP address and shared disk
2. Database for Common Component
3. HBase 64 Storage Mgmt SSO Service
4. HBase 64 Storage Mgmt Web SSO Service
5. HBase 64 Storage Mgmt Web Service
6. HAutomation Engine Web Service
Use the cluster software to bring the resource group online.