5.1 Procedure for installing JP1/AO in a cluster system

After checking the prerequisites, install JP1/AO in both the active server and standby server.

To install JP1/AO in a cluster system, perform the procedure described below.

Table 5‒1: Procedure for installing JP1/AO in a cluster system

Task		Required/optional	Reference
1	Check the installation prerequisites.	Required	5.2 Installation prerequisites (for cluster systems)
2	Install JP1/AO.	Required	The reference depends on the current environment and the installation status of the product.#
3	Install the manual on the JP1/AO server.	Optional	1.4 Procedure to install the manual
4	Install JP1/AO Content Pack.	Optional	1.5 Installing JP1/AO Content Pack

#

The procedure for installing JP1/AO differs depending on the current configuration of the environment and on whether products have been installed.

Table 5‒2: Possible environments when setting up a cluster system

Current environment	JP1/AO installation status	Common Component installation status	Reference
Cluster system set up	Y	Y	6.5 Procedure to perform an overwrite or upgrade installation of JP1/AO (for a Windows cluster system)
	N	Y	5.4 Installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)
		N	5.3 Installing JP1/AO in a cluster system
Cluster system not set up	N	Y
		N

Legend:

Y: installed N: not installed

Note that cluster systems built in either of the following ways are not supported:

• A non-cluster environment in which JP1/AO is already operating is rebuilt in a cluster configuration later.

• A Linux cluster system is newly built in an environment in which Common Component has already been installed.

To Page Top