5.4.6 Procedure to register services by using the cluster software (if Common Component is already installed)

To register services by using the cluster software:

1. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the active server.

2. Use the cluster software to register services in the resource group where the Hitachi Command Suite products are registered.

   Set the service dependencies in the order listed below. In the case of HiRDB/ClusterService _HD1, set the dependency to the shared disk and client access point.

   1. HiRDB/ClusterService _HD1

   2. HBase 64 Storage Mgmt SSO Service

   3. HBase 64 Storage Mgmt Web Service

   4. HBase 64 Storage Mgmt Web SSO Service

   5. HAutomation Engine Web Service

   If values are specified in Startup Parameters in the General Tab, remove the values.

3. In the cluster software, enable failover for the resource group where the Hitachi Command Suite products are registered.

   Right-click a service or script in the cluster software, select Properties, and then Policies. Then, specify the settings so that a restart can be attempted on the current node if the resource fails and all resources in the target service or application can be failed over if restart fails. Perform this action for all services and scripts registered in the resource group in order to enable failover.

4. Bring the resource group online by using the cluster software.