uCosminexus Service Platform, Basic Development Guide

[Contents][Glossary][Index][Back][Next]

6.6 Specifying Looping

In mapping that uses the loop node function, you can synthesize loops and change the looping dependent target.

Organization of this section
6.6.1 Mapping Using the Loop Settings Dialog Box
6.6.2 Synthesizing Loops
6.6.3 Mapping Looping Dependent Targets
6.6.4 Checking Looping Dependent Targets
6.6.5 Changing Looping Dependent Targets
6.6.6 Displaying the Path of a Transformation-source Node for Which a Looping Dependent Target Is Specified
6.6.7 Relating repeat process of each element by setting up the linkage path