uCosminexus Service Platform, Basic Development Guide

[Contents][Glossary][Index][Back][Next]

6.6.4 Checking Looping Dependent Targets

To check the looping dependent targets that were automatically set up:

  1. In the schema tree viewer, right--click the descendant node of the transformation-destination node for which a loop was set up, and click Mapping source.
    The Settings for Mapping Source dialog box opens.

    [Figure]

    The relative path from the transformation-source node for which the loop node function was mapped is displayed in Path/Function name. For details about how to display path names, see 6.6.6 Displaying the Path of a Transformation-source Node for Which a Looping Dependent Target Is Specified. The function name that becomes the looping dependent target is displayed in Dependent target.