5.2.2 List of commands of command utility
This subsection lists and describes the commands of the command utility as per the managed items. Note that when the status of the CJMSP broker is SHUTDOWN_COMPLETE (status where termination process is completed), these commands do not operate normally.
- Organization of this subsection
(1) CJMSP Broker management
Command name |
Description |
---|---|
Lists and displays the status of CJMSP Broker. |
|
Temporarily stops the running CJMSP Broker. |
|
Lists and displays the property value of CJMSP Broker. |
|
Resumes CJMSP Broker. |
|
Stops CJMSP Broker. |
(2) Connection service management
Command name |
Description |
---|---|
Lists and displays the usable connection services. |
(3) Physical destination management
Command name |
Description |
---|---|
Compresses physical destinations. |
|
Creates a physical destination. |
|
Destroys the physical destination. |
|
Lists and displays the physical destination. |
|
Temporarily stops the message delivery to physical destination. |
|
Deletes all the messages from physical destination. |
|
Lists and displays the property values of physical destination. |
|
Resumes the message delivery to physical destination. |
(4) Persistence subscriber management
Command name |
Description |
---|---|
Destroys persistence subscriber. |
|
Lists and displays the persistence subscriber. |
|
Deletes all the messages of persistence subscriber. |
(5) Common options of command utility
There are some common options that you can specify in all commands with the command utility. The following table lists and describes the common options of the command utility:
Option name |
Description |
---|---|
-rtm timeoutInterval |
Specifies an initial value of the timeout interval (unit: seconds) as an integer from 0 to 2147483647. The initial value is the time for which you wait for a response from the CJMSP Broker after executing a command until the request is sent again. The retry interval is set up in multiples of the initial value of the timeout interval. The default value is 10 seconds. Also, if you specify 0, a timeout does not occur. |
-b host-name:port-number |
Specifies the host name (or IP address) and the port number connected to CJMSP Broker. The default value is as follows:
An error message is displayed, if you do not set up a correct value when the CJMSP Broker instance is started at the remote host. If you specify only the port number and omit the host name, CJMSP Broker of the local host is connected. For example, when you specify :7676 has the same meaning when you specify localhost:7676. |
-f |
Executes the command without a confirmation from the user. |
-h | -help |
Displays help. |