5.4.4 Procedure for setting up the active server (if Common Component is already installed)

Set up the active server.

To set up the active server:

1. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the active server.

2. Set up the JP1/Base cluster environment on the active server.

   When you set up JP1/Base, specify the same logical host name as for JP1/AO.

   For the primary authentication server of the logical host name in JP1/Base, specify the same logical host name as for JP1/AO. If you specify a different authentication server, make sure that you can establish communication with the authentication server you specify. In addition, make sure that the JP1 users registered on the authentication server satisfy the following constraints.

   • They must be able to be mapped to OS users.

   • They must have the permissions described in Table 1‒2: JP1 user permission levels and have access to JP1 resource groups

3. If the HAutomation Engine Web Service is running on the active server, stop it by executing the hcmdssrv command with the /stop /server AutomationWebService option specified.

4. Execute the setupcluster command on the active server.

Related topics

• 1.2.3 Creating a JP1 user in JP1/Base

• Setting Up JP1/Base for Use in a Cluster System in the Job Management Partner 1/Base User's Guide

• JP1/AO services in the Job Management Partner 1/Automatic Operation Administration Guide

To Page Top