5.4 Installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration)
To set up a cluster system, you must install JP1/AO on both the active server and standby server.
To install JP1/AO, perform the procedure described below.
Task |
Required/optional |
Reference |
|
---|---|---|---|
1 |
Perform the tasks that must be completed in advance. |
Required |
|
2 |
Configure services before installation (if Common Component is already installed). |
Required |
|
3 |
Install JP1/Base and JP1/AO on the active and standby servers (if Common Component is already installed). |
Required |
|
4 |
Set up the active server (if Common Component is already installed). |
Required |
5.4.4 Procedure for setting up the active server (if Common Component is already installed) |
5 |
Set up the standby server (if Common Component is already installed). |
Required |
5.4.5 Procedure for setting up the standby server (if Common Component is already installed) |
6 |
Register services by using the cluster software (if Common Component is already installed). |
Required |
Related topics