5.4.3 Procedures for installing JP1/Base and JP1/AO on the active server and standby server (if Common Component is already installed)

Install JP1/Base and JP1/AO on the active server and standby server.

To install JP1/Base and JP1/AO on the active server and standby server:

1. Install JP1/Base on the active server.

   For the JP1/Base installation destination, specify the same drive and folder names in the active server and standby server.

   After installation, if a message is displayed indicating that a restart is required, restart the active server.

2. Create a JP1 user in JP1/Base on the active server.

   For details, see 1.2.3 Creating a JP1 user in JP1/Base.

3. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the active server.

4. Install JP1/AO on the active server.

   • Specify a path on a shared disk for the location of the database.

   • Specify the logical host name for the JP1/AO server host name.

   • For the JP1/AO and JP1/AJS3 - Manager installation destination, specify the same drive and folder names in the active server and standby server.

   After installation, if a message is displayed indicating that a restart is required, restart the active server.

5. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the standby server.

6. Install JP1/Base on the standby server.

   For the JP1/Base installation destination, specify the same drive and folder names in the active server and standby server.

   After installation, if a message is displayed indicating that a restart is required, restart the active server.

7. Create a JP1 user in JP1/Base on the standby server.

   For details, see 1.2.3 Creating a JP1 user in JP1/Base.

8. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the standby server.

9. Install JP1/AO on the standby server.

   • Specify a path on a shared disk for the location of the database.

   • Specify the logical host name for the JP1/AO server host name.

   • For the JP1/AO and JP1/AJS3 - Manager installation destination, specify the same drive and folder names in the active server and standby server.

   After installation, if a message is displayed indicating that a restart is required, restart the active server.

Related topics

• 1.2.3 Creating a JP1 user in JP1/Base

• Setting Up JP1/Base for Use in a Cluster System in the Job Management Partner 1/Base User's Guide

To Page Top