1.2.3 Creating a JP1 user in JP1/Base
To install JP1/AO, the JP1 users must be registered in advance. Make sure that there is at least one JP1 user, and that the user mapping has been done.
To use a jp1admin user or users used in the existing JP1/Base, you must also confirm that the user is mapped to an OS user with Administrator permissions and that the permission levels shown in the table below are granted.
To create a JP1 user in JP1/Base:
-
Create a JP1 user using JP1/Base, and then set the permission levels as shown in the following table.
Table 1‒2: JP1 user permission levels Permission
JP1 resource group
JP1_AO_Admin
* (Indicates that access to all JP1 resource groups is possible.)
JP1_AJS_Manager
JP1_JPQ_Admin
-
Map the created JP1 user to an OS user with Administrator permissions. To map a user other than a built-in administrator who belongs to the Administrator group, disable UAC. If UAC is enabled, an attempt to run a service fails.
- Tip
-
If you edit Service Share Properties immediately after installing JP1/AO, you can change the JP1 users who use JP1/AO.
Related topics
-
User Management Setup in the Job Management Partner 1/Base User's Guide
-
List of shared built-in service properties in the Job Management Partner 1/Automatic Operation Administration Guide