5.3.6 Procedure to register services by using the cluster software
Register services by using the cluster software.
To register services by using the cluster software:
-
Move Current Owner to the active server by using the cluster software.
-
Register services to the resource group by using the cluster software.
Set the service dependencies in the order listed below. In the case of JP1/Base Event logical-host-name, set the dependency to the shared disk and client access point.
Register 1 to 7 as service resources. Register 8 as a script resource.
-
JP1/Base Event logical-host-name
-
JP1/Base_logical-host-name
-
HiRDB/ClusterService _HD0
-
HBase Storage Mgmt Common Service
-
HBase Storage Mgmt Web Service
-
HAutomation Engine Web Service
-
HAutomation Engine logical-host-name
-
stopcluster command
Here, logical-host-name means the logical host name specified in the cluster settings file.
If values are specified in Startup Parameters in the General Tab, remove the values.
For the stopcluster command, specify any value for the resource name and executable script name. Specify the stopcluster command to be executed only when this resource is placed offline. For details about how to specify the command, refer to the documentation of your cluster software.
Note that, if this resource is accidentally executed online, a KNAE01635-E message is output and task operation fails. In this case, stop JP1/AO, specify this resource to be executed only offline, and then restart JP1/AO.
-
-
Bring the resource group online by using the cluster software.
Related topics
-
Setting Up JP1/Base for Use in a Cluster System in the Job Management Partner 1/Base User's Guide