5.3 Installing JP1/AO in a cluster system
To set up a cluster system, you must install JP1/AO on both the active server and standby server.
When you set up JP1/AO in a cluster system, it also sets up Common Component, which is used by Hitachi Command Suite products.
To install JP1/AO, perform the procedure described below.
Task |
Required/optional |
Reference |
|
---|---|---|---|
1 |
Perform the tasks that must be completed in advance. |
Required |
5.3.1 Tasks required before installation of JP1/AO in a cluster system |
2 |
Create a resource group by using the cluster software. |
Required |
5.3.2 Procedure for creating a resource group by using the cluster software |
3 |
Install JP1/Base and JP1/AO on the active server and standby server. |
Required |
5.3.3 Procedures for installing JP1/Base and JP1/AO on the active server and standby server |
4 |
Set up the active server. |
Required |
|
5 |
Set up the standby server. |
Required |
|
6 |
Register services by using the cluster software. |
Required |
5.3.6 Procedure to register services by using the cluster software |
Related topics
- Organization of this section
-
-
5.3.1 Tasks required before installation of JP1/AO in a cluster system
-
5.3.2 Procedure for creating a resource group by using the cluster software
-
5.3.3 Procedures for installing JP1/Base and JP1/AO on the active server and standby server
-
5.3.6 Procedure to register services by using the cluster software
-