Hitachi

Job Management Partner 1 Version 10 Job Management Partner 1/Automatic Operation Configuration Guide


5.4.5 Procedure for setting up the standby server (if Common Component is already installed)

Set up the standby server.

To set up the standby server:

  1. Use the cluster software to move the resource group where the Hitachi Command Suite products are registered to the standby server.

  2. Set up the JP1/Base cluster environment on the standby server.

    When you set up JP1/Base, specify the same logical host name as for JP1/AO.

    For the primary authentication server of the logical host name in JP1/Base, specify the same logical host name as for JP1/AO. If you specify a different authentication server, make sure that you can establish communication with the authentication server you specify. In addition, make sure that the JP1 users registered on the authentication server satisfy the following constraints.

  3. If the HAutomation Engine Web Service is running on the standby server, stop it by executing the hcmdssrv command with the /stop /server AutomationWebService option specified.

  4. Execute the setupcluster command on the standby server.

Related topics