5.1.12 Undoing the ITSLM - UR setup
You must undo the ITSLM - UR setup before you can set up ITSLM - UR again.
When setup is undone, the settings in the system definition files that have been edited by the user are initialized. Before you unto setup, be sure to back up the system definition files, if necessary.
For details about backing up the system definition files, see 8.1.1 Backing up the definition files.
This subsection explains how to undo the setup of ITSLM - UR.
- Organization of this subsection
(1) Before you start
-
Verify that setup of ITSLM - UR whose setup is to be undone has been completed.
-
Terminate the ITSLM - UR whose setup is to be undone.
For details about the termination method, see 2.1.3 Terminating ITSLM - UR.
(2) Procedure
To undo the ITSLM - UR setup:
-
Execute the unsetup command.
Execute the following unsetup command:
ITSLM-UR-installation-folder\ur\bin\jslmurunsetup
For details about the unsetup command, see jslmurunsetup (undoes the ITSLM - UR setup) in 9. Commands.
When the command terminates normally, undoing of the ITSLM - UR setup is complete.