5.1.11 Undoing the ITSLM - Manager setup
You must undo the ITSLM - Manager setup before you can set up ITSLM - Manager again.
When setup is undone, the settings in the system definition files that have been edited by the user and the database information are initialized. Before you unto setup, be sure to back up the system definition files and database, if necessary.
For details about backing up the system definition files, see 8.1.1 Backing up the definition files, and for details about backing up the database, see 8.1.2 Backing up the database.
This subsection explains how to undo the setup of ITSLM - Manager.
- Organization of this subsection
(1) Before you start
-
Verify that setup of ITSLM - Manager whose setup is to be undone has been completed.
-
Terminate the ITSLM - Manager whose setup is to be undone.
For details about the termination method, see 2.1.4 Terminating ITSLM - Manager.
(2) Procedure
To undo the ITSLM - Manager setup:
-
Execute the unsetup command.
Execute the following unsetup command:
ITSLM-Manager-installation-folder\mgr\bin\jslmmgrunsetup
For details about the unsetup command, see jslmmgrunsetup (undoes ITSLM - Manager setup) in 9. Commands.
When the command terminates normally, undoing of the ITSLM - Manager setup is complete.