8.1.1 Backing up the definition files
The following are the ITSLM definition files:
-
System definition files: jp1itslm.properties and jp1itslmur.properties
-
System configuration properties file: system_config.properties
You must back up these definition files manually.
This subsection explains how to back up the definition files.
We recommend that you always back up the system definition files after you have edited them.
- Organization of this subsection
(1) Before you start
-
Verify that setup of the applicable ITSLM - Manager or ITSLM - UR has been completed.
For details about how to set up ITSLM - Manager, see 5.1.6 Setting up ITSLM - Manager; for details about how to set up ITSLM - UR, see 5.1.7 Setting up ITSLM - UR.
(2) Procedure
To back up the definition files:
-
Copy the definition files to a desired location.
Copy the following definition files:
- Definition files for ITSLM - Manager:
-
![[Figure]](GRAPHICS/ZUENG030.GIF)
ITSLM-Manager-installation-folder\ mgr\conf\jp1itslm.properties ITSLM-Manager-installation-folder\ mgr\sdpengine\analysisN#\conf\system_config.properties#: N is a number from 1 through 10.
- Definition files for ITSLM - UR:
-
ITSLM-UR-installation-folder\ ur\conf\jp1itslmur.properties ITSLM-UR-installation-folder\ ur\sdpengine\collector\conf\system_config.properties ITSLM-UR-installation-folder\ ur\sdpengine\collector2\conf\system_config.properties ITSLM-UR-installation-folder\ ur\sdpengine\recorder\conf\system_config.properties
When you have finished copying the definition files, the task of backing up the definition files is complete.
(3) Supplementary information
-
You can back up the definition files regardless of whether ITSLM - Manager or ITSLM - UR services are running.