5.1.7 Setting up ITSLM - UR
The purpose of setup is to create an execution environment.
You can set up either ITSLM - UR or ITSLM - Manager first.
This subsection explains how to set up ITSLM - UR.
- Organization of this subsection
(1) Before you start
-
Verify that your user account belongs to the OS's Administrators group.
-
Before you start the setup, install the ITSLM - UR that is to be set up.
For details about the installation, see 5.1.5 Installing ITSLM.
(2) Procedure
To set up ITSLM - UR:
-
Execute the command that checks the network interface number and IP address of the host on which ITSLM - UR has been installed.
Execute the following command:
ITSLM-UR-installation-folder\ur\bin\jslmuripls
For details about the command that checks the network interface number and IP address, see jslmuripls (displays network interface number and IP address) in 9. Commands.
-
Create the options file required for setup based on the information provided by executing the jslmuripls command.
For details about the options file, see jslmursetup (sets up ITSLM - UR) in 9. Commands.
-
Store the created options file in a desired folder.
Make sure that the absolute path of the options file storage location does not exceed 255 bytes including the options file name (any name).
-
Execute the setup command.
The following shows the setup command that is to be executed:
ITSLM-UR-installation-folder\ur\bin\jslmursetup absolute-path-of-options-file
For details about the setup command, see jslmursetup (sets up ITSLM - UR) in 9. Commands.
When the command terminates normally, ITSLM - UR setup is complete.
To log an access history, you must set the access log folder for the accesslogFilePath property in the ITSLM - UR system definition file (jp1itslmur.properties). For details about how to set this folder, see "5.6 Editing the system definition files to change settings".
(3) Supplementary information
-
If a firewall has been set up on the host on which ITSLM - UR has been set up, you must release the port number that was specified for the ur_port definition item in the options file used during setup. If you change the settings in the options file, you must also change the firewall settings, and then check the following:
-
Check if ephemeral ports for communication between ITSLM - UR and ITSLM - Manager are released.
If they have not been released, set up the firewall to release the ephemeral ports or set up the firewall to allow communication from the following programs:
ITSLM-UR-installation-folder\ur\bin\system\jslmuUR.exe
ITSLM-UR-installation-folder\ur\bin\system\jslmuRMI.exe
-
-
To adjust the time of the host on which ITSLM - UR has been set up, you must first terminate all ITSLM - Managers and ITSLM - URs.
Adjust ITSLM - UR's time to ITSLM - Manager's time. If ITSLM - UR's time moved backward (earlier) as a result of adjustment, there is no need to wait to start ITSLM - UR until the amount of time that moved backwards has elapsed. However, if monitoring of monitored services starts while ITSLM - UR's time is in the past, the service performance data acquired by ITSLM - UR is discarded until the last monitoring period has elapsed.