Disconnecting the controller

This subsection describes the procedure for disconnecting the controller from the agent side. You can either disconnect controllers on an individual basis, or disconnect all of them in a single operation. The description here focuses on menu operations, but note that you can also use buttons if the Status window is shown.

In addition, you configure the environment settings to automatically terminate Remote Control Agent when the connection with the last controller is severed. If the system has not been configured to exit automatically, the agent will be reconnected if a controller requests another connection.

Organization of this subsection: (1) Disconnecting controllers individually; (2) Disconnecting all controllers

(1) Disconnecting controllers individually

Perform the following steps to disconnect controllers individually.

Right-click the Remote Control Agent icon or anywhere in the Status window, and choose Disconnect.
A list of connected controllers appears at the bottom of the menu.
Select the controller you want to disconnect.
The connection with the selected controller will be severed.

When the status window is displayed, you can also use the [Figure] button instead of the menu.

(2) Disconnecting all controllers

Perform the following steps to disconnect all the connected controllers.

Right-click the Remote Control Agent icon or anywhere in the Status window, and choose Disconnect All.
Connections with all the connected controllers will be severed.

When the status window is displayed, you can also use the [Figure] button instead of the menu.

5.2.4 Disconnecting the controller

(1) Disconnecting controllers individually

(2) Disconnecting all controllers