When you install JP1/Software Distribution Client, you choose whether it will be used as a relay system or as a client.

The following figure shows the procedure for installing JP1/Software Distribution Client as a relay system or client.

Figure 3-1 JP1/Software Distribution Client installation procedure

If you select Packager or Remote Control Agent as an installation component in addition to Relay system or Client, you must also set up the selected component during installation.

When the pre-installation facility is used, you can install JP1/Software Distribution Client in one computer and then copy its hard disk. For details about how to install JP1/Software Distribution Client using the pre-installation facility, see 1.2.3 Using the pre-installation facility to install JP1/Software Distribution Client (client).

The steps in the installation procedure are explained below.

Organization of this section

3.1.1 Logging on

3.1.2 Starting the installer

3.1.3 Registering the user

3.1.4 Specifying the installation directory

3.1.5 Selecting the type

3.1.6 Selecting the components

3.1.7 Selecting the program folder

3.1.8 Specifying work directories

3.1.9 Specifying the connection destination

3.1.10 Specifying the ID key for operations

3.1.11 Setting the network

3.1.12 Specifying the dial-up settings

3.1.13 Specifying options

3.1.14 Setting up AMT Linkage

3.1.15 Specifying the connection destination (Packager)

3.1.16 Checking the Notes for the Remote Control Agent

3.1.17 Confirming the installation

3.1.18 Finishing the installation