Specify the connection destination of the Packager. The Specify Connection Destination dialog box is displayed when the Packager is being installed.

You can change these settings in the Software Distribution Manager Logon dialog box of the Software Distribution Packager window.

Figure 3-18 Specify Connection Destination dialog box

Product type

Select either Software Distribution Manager, Software Distribution Client (relay system) or Software Distribution SubManager as the connection destination of the Packager. The default is Software Distribution Manager.

Connection destination

Specify the host name or IP address of the connection destination of the Packager. The default is None.

Dial-up connection

If the Packager is to use dial-up connection to connect to the higher system, select this check box. The default is that the check box is not selected.

This check box is displayed only for a client; it is not displayed for a relay system.

Click the Next button to continue with installation. If you selected Dial-up connection, the Dial-up Settings dialog box appears; the settings are the same as when Client uses dial-up connection. For details, see 3.1.12 Specifying the dial-up settings. You must set up the dial-up connection for the Packager separately from the dial-up connection for the client. You can use dial-up connection for only one of them.