The table below lists the commands used for setting up the server start, termination, and monitoring commands.

Table 4-1 Commands used for setting up the server start, termination, and monitoring commands

Command name	Function	Relevant subcommands#
haorainsbgn	Starts an Oracle instance.	haoraenvcheck
haorainsend	Terminates an Oracle instance.	haoraenvcheck haorainsendsub
haorainsptl	Checks the status of an Oracle instance.	haoraenvcheck haorainsptlsub
haoralsnrbgn	Starts an Oracle listener.	haoraenvcheck
haoralsnrend	Terminates an Oracle listener.	haoraenvcheck haoralsnrendsub
haoralsnrptl	Checks the status of an Oracle listener.	haoraenvcheck haoralsnrptlsub

#

The subcommands are invoked from the command shown in the first column. Therefore, there is no need to set them in the server start, termination, and monitoring commands.

Organization of this section

Headings used for describing the commands

Syntax conventions

haorainsbgn (Starts an Oracle instance)

haorainsend (Terminates an Oracle instance)

haorainsptl (Checks the status of an Oracle instance)

haorainsendsub (Terminates an Oracle instance)

haorainsptlsub (Checks the status of an Oracle instance)

haoralsnrbgn (Starts an Oracle listener)

haoralsnrend (Terminates an Oracle listener)

haoralsnrptl (Checks the status of an Oracle listener)

haoralsnrendsub (Terminates an Oracle listener)

haoralsnrptlsub (Checks the status of an Oracle listener)

haoraenvcheck (Checks a control definition file)