1.18.1 Settings for using the functions of the Intelligent Integrated Management Base (for Windows)
When you install JP1/IM - Manager for the first time, the functions of the Intelligent Integrated Management Base are disabled by default.
To use the functions of the Intelligent Integrated Management Base, perform the following steps:
-
Set the integrated monitoring database.
-
Enable event source host mapping.
Execute jcoimdef -hostmap ON.
-
Enable the Intelligent Integrated Management Base service (jddmain).
Execute jcoimdef -dd ON.
-
Start JP1/IM - Manager.
-
Confirm that the Intelligent Integrated Management Base service is up and running.
Execute the jco_spmd_status command. Confirm that jddmain is displayed as an active process.
For details about the integrated monitoring database, see 1.4.2 Setting up the integrated monitoring database (for Windows).
For details about the jcoimdef command, see jcoimdef in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.
- Important
-
Once you configure the Intelligent Integrated Management Base, it will take longer for the JP1/IM - Manager service to start. If your clustering software monitors the start-up time of the JP1/IM - Manager service or the startup control of JP1/Base is used to start the JP1/IM - Manager service, you need to check and, if necessary, revise the timeout value of the software. After configuring the Intelligent Integrated Management Base, check the start-up time of the service and adjust the timeout value.