Hitachi

JP1 Version 12 JP1/Integrated Management 2 - Manager Configuration Guide


1.4.2 Setting up the integrated monitoring database (for Windows)

Create an integrated monitoring database and use the Intelligent Integrated Management Base or the Central Console functions to set up the database so you can use it. If you do not plan to use the integrated monitoring database, there is no need to perform this procedure.

The setup procedure differs depending on whether the IM Configuration Management database has already been set up. Apply the following procedures as appropriate depending on the case.

Organization of this subsection

(1) When the IM Configuration Management database has been set up

The setup procedure differs depending on whether you stop JP1/IM-Manager Service. The following are the setup procedures for the two cases.

  1. Check if the IM database service (JP1/IM2-Manager DB Server) is running.

  2. Stop the following services:

    • JP1/IM-Manager Service

    • If JP1/IM - MO is being used, the JP1/IM - Message Optimizer service of JP1/IM - MO at the connection source.

  3. Execute the jcodbsetup command to create an integrated monitoring database.

    jcodbsetup -s [-q]

  4. Execute the jcoimdef command to enable the integrated monitoring database.

    jcoimdef -db ON

  5. Start JP1/IM-Manager Service.

  1. Execute the jcoimdef command to disable the IM Configuration Management service (jcfmain).

    jcoimdef -cf OFF

  2. Restart JP1/IM-Manager Service.

  3. Check if the IM database service (JP1/IM2-Manager DB Server) is running.

  4. Stop the following service:

    • If JP1/IM - MO is being used, the JP1/IM - Message Optimizer service of JP1/IM - MO at the connection source.

  5. Execute the jcodbsetup command to create an integrated monitoring database.

    jcodbsetup -s [-q]

  6. Execute the jcoimdef command to enable the integrated monitoring database.

    jcoimdef -db ON

  7. Execute the jcoimdef command to enable the IM Configuration Management service (jcfmain).

    jcoimdef -cf ON

  8. Restart JP1/IM-Manager Service.

For details about the jcodbsetup command, see jcodbsetup in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.

For details about the jcoimdef command, see jcoimdef in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.

(2) When the IM Configuration Management database has not been set up

  1. Stop the following service:

    • If JP1/IM - MO is being used, the JP1/IM - Message Optimizer service of JP1/IM - MO at the connection source.

  2. Execute the jcodbsetup command to create an integrated monitoring database.

    jcodbsetup -f setup-information-file-name [-q]

  3. Execute the jcoimdef command to enable the integrated monitoring database.

    jcoimdef -db ON

  4. Restart JP1/IM-Manager Service.

For details about the jcodbsetup command, see jcodbsetup in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.

For details about the jcoimdef command, see jcoimdef in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.