1. Installation and Setup (for Windows)

Organization of this chapter

• 1.1 Installation and setup procedures (for Windows)

• 1.2 Preparations required before installation (for Windows)

• 1.3 Installing JP1/IM - Manager and JP1/IM - View (for Windows)

• 1.4 Creating IM databases (for Windows)

• 1.5 Setting the startup sequence for services (for Windows)

• 1.6 Setting up user authentication and user mapping (for Windows)

• 1.7 Specifying settings for handling JP1/Base failures (for Windows)

• 1.8 Setting the system hierarchy (when IM Configuration Management is used) (for Windows)

• 1.9 Setting the system hierarchy (when IM Configuration Management is not used) (for Windows)

• 1.10 Setting up Event Service (for Windows)

• 1.11 Setting JP1 event forwarding when IM Configuration Management is used (for Windows)

• 1.12 Setting JP1 event forwarding when IM Configuration Management is not used (for Windows)

• 1.13 Collecting and distributing Event Service definition information when IM Configuration Management is used (for Windows)

• 1.14 Collecting and distributing Event Service definition information when IM Configuration Management is not used (for Windows)

• 1.15 Setting up a command execution environment (for Windows)

• 1.16 Specifying settings for using the source host name of Event Service in the FQDN format (for Windows)

• 1.17 Specifying settings for monitoring logs on remotely monitored hosts (for Windows)

• 1.18 Setting up JP1/IM - Manager (for Windows)

• 1.19 Setting up JP1/IM - View (for Windows)

• 1.20 Saving manuals to a computer (for Windows)

• 1.21 Uninstallation (for Windows)

• 1.22 Notes about installation and setting up (for Windows)

To Page Top