1.18.2 Specifying settings for using the functions of Central Scope (for Windows)
When a new installation of JP1/IM - Manager is performed, the functions of Central Scope are disabled by default.
To use the functions of Central Scope:
-
Create a Central Scope database.
Execute the Scope-path\bin\jcsdbsetup command. Specify options as needed.
-
Enable Central Scope Service (jcsmain).
Execute jcoimdef -s ON.
-
Start JP1/IM - Manager.
-
Verify that Central Scope Service is running.
Execute the jco_spmd_status command. Make sure that jcsmain is displayed as an active process.
For details about the jcsdbsetup command, see jcsdbsetup in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.
For details about the jcoimdef command, see jcoimdef in Chapter 1. Commands in the manual JP1/Integrated Management 2 - Manager Command, Definition File and API Reference.
- Important
-
About reconfiguration of the central scope database
After you uninstall JP1/IM - Manager and then re-install it or execute the jcsdbsetup command, if you connect JP1/IM - View, the [Monitoring Tree] window may display the information that exists before re-installation or execution of the command. If old information is displayed, stop JP1/IM - View, delete the following folder, and then
restart JP1/IM - View:
<system-drive>:\ProgramData\HITACHI\JP1\JP1_DEFAULT\JP1CoView\log\output