Summary of amendments

In the Event Console window, the Action column now shows an icon indicating that the event is excluded from action execution by a common exclusion-condition (action execution).

2.1

The configuration file for incident inheritance information (incident_info.conf) was added to the relation definition files of the Event Details window and the Edit Event Details window.

2.6, 2.7

The maximum number of defined common exclusion-conditions groups (in extended mode) was increased to 2,500.

2.11.1, 2.14, 2.16

For common exclusion-conditions in extended mode, in the System Environment Settings window, the Type column of the General page now shows an icon indicating that the common exclusion-condition excludes a collected event from action execution.

2.11.1

For common exclusion-conditions in extended mode, in the Event Acquisition Conditions List window, the Type column of the Common exclusion-conditions groups list now shows an icon indicating that the common exclusion-condition excludes a collected event from action execution.

2.14

In the Common Exclusion-Condition Settings (Extended) window, you can now specify the exclusion target.

2.16

The maximum number of defined conditions in the list of repeated event conditions was increased to 2,500.

2.19

The event list in the Event Console window can now show the following items:

• Common exclude conditions group ID

• Common exclude conditions group name

• Common exclude conditions group target-for-exclusion

2.24.2

You can now enable or disable automated action definitions in the Action Parameter Definitions window.

2.32

When you apply changes in the Action Parameter Definitions window, you can now retain the suppression status and the status of satisfied conditions of the AND-joined conditions unless the action definition is edited.

2.32

You can now specify an action ID of the action execution condition in the Action Parameter Detailed Definitions window.

2.33.1

A note was added for cases where a large number of agents are requested at once to execute a command.

2.40