9.2 JP1/AO system migration procedure (to an environment with a different host name or IP address)
To migrate a JP1/AO system to an environment with a different host name or IP address , you must change the host name or IP address of the target server to those of the original server. After restoring JP1/AO, reset the host name or IP address of the target server to the one before the change.
Prerequisites
-
The following items must match on the original server and the target server:
-
System locale
-
The environment for Hitachi Command Suite products (configuration, version, and revision)
-
-
No tasks must be in the In Progress, Waiting for Response, Abnormal Detection, or Terminated status on the original JP1/AO server.
-
JP1/Base and JP1/AO must not be installed on the target server.
When to restore JP1/Base, which is a prerequisite product of JP1/AO, depends on whether the original JP1/AO server has been upgraded from version 10-00..
-
If the JP1/AO server has been upgraded from version 10-00.:
Restore JP1/Base before you start the JP1/AO restore operation.
-
If the JP1/AO server has not been upgraded from version 10-00.:
Restore JP1/Base as part of the JP1/AO restore operation.
The following describes the migration procedure depending on whether the original JP1/AO server has been upgraded.
If the JP1/AO server has not been upgraded from version 10-00:
Task |
Reference |
|
---|---|---|
1 |
Back up JP1/AO on the original server. |
Topics about backup in the Job Management Partner 1/Automatic Operation Administration Guide |
2 |
Change the host name and IP address of the target server to match the migration source environment. |
-- |
3 |
Install JP1/Base and JP1/AO on the target server. Make sure that the following items match on the original server and the target server:
|
|
4 |
Restore JP1/AO on the target server. |
Topics about restoration in the Job Management Partner 1/Automatic Operation Administration Guide |
5 |
Return the host name and IP address of the target server to those before the migration. Perform the procedure for changing the host name and IP address. |
|
6 |
Make sure that the target server is running, and then start operations. |
-- |
- Legend:
-
--: None
If the JP1/AO server has been upgraded from version 10-00:
Task |
Reference |
|
---|---|---|
1 |
Back up JP1/AO on the original server. |
Topics about backup in the Job Management Partner 1/Automatic Operation Administration Guide |
2 |
Change the host name and IP address of the target server to match the migration source environment. |
-- |
3 |
Install and restore JP1/Base on the target server. Make sure that the following items match on the original server and the target server:
|
1.2.2 Installing JP1/Base, 1.2.3 Creating a JP1 user in JP1/Base |
4 |
Install JP1/AO on the target server. At this time, JP1/AO must be installed in the same folder as the installation folder on the original server. |
|
5 |
Restore JP1/AO on the target server. There is no need to restore JP1/Base because it has been restored in step 3. |
Topics about restoration in the Job Management Partner 1/Automatic Operation Administration Guide |
6 |
Return the host name and IP address of the target server to those before the migration. Perform the procedure for changing the host name and IP address. |
|
7 |
Make sure that the target server is running, and then start operations. |
-- |
- Legend:
-
--: None