5.1 Procedure for installing JP1/AO in a cluster system
After checking the prerequisites, install JP1/AO in both the active server and standby server.
To install JP1/AO in a cluster system, perform the procedure described below.
Task |
Required/optional |
Reference |
|
---|---|---|---|
1 |
Check the installation prerequisites. |
Required |
|
2 |
Install JP1/AO. |
Required |
The reference depends on the current environment and the installation status of the product.# |
3 |
Install the manual on the JP1/AO server. |
Optional |
|
4 |
Install JP1/AO Content Set. |
Optional |
- #
-
The procedure for installing JP1/AO depends on the current environment and the installation status of the product.
Table 5‒2: Possible environments when setting up a cluster system Current environment
JP1/AO installation status
Common Component installation status
Reference
Cluster system set up
Y
Y
6.3 Procedure to perform an overwrite installation of JP1/AO (cluster system)
N
Y
N
Cluster system not set up
N
Y
N
- Legend:
-
Y: installed N: not installed
Note that migrating an installation of JP1/AO that is operating in a non-cluster system environment to a cluster configuration is not supported.
Before installing JP1/AO, you need to install JP1/Base, which is prerequisite software. For details about how to install and set up JP1/Base, see the procedure in 5.3 Installing JP1/AO in a cluster system or 5.4 Installing JP1/AO in a cluster system (if Common Component is already installed in a cluster configuration).