1.1 New installation procedure
After checking the prerequisites and installing JP1/Base, install JP1/AO from the distribution media.
The following table describes the procedure for a new installation.
Task |
Required/optional |
Reference |
|
---|---|---|---|
1 |
Check the installation prerequisites. |
Required |
|
2 |
Install JP1/Base on the JP1/AO server (the server on which you plan to install JP1/AO). |
Required |
|
3 |
You must register a JP1 user before you can install JP1/AO. If you want to use a user other than jp1admin or a user who is not yet defined in the existing JP1/Base, create the desired JP1 user in JP1/Base. |
Optional |
|
4 |
If the OS at the JP1/AO installation destination is Windows Server 2012 or Windows Server 2012 R2, you must install .NET Framework 3.5. If the OS is Windows Server 2008, .NET Framework 3.5 is installed by default. |
Optional |
1.2.4 Installing. NET Framework (Windows Server 2012 or Windows Server 2012 R2) |
5 |
Perform a new installation of JP1/AO from the distribution media. |
Required |
|
6 |
Install the manual on the JP1/AO server. |
Optional |
|
7 |
Install JP1/AO Content Set. |
Optional |
|
8 |
Enable HTTPS connections between Web browsers and JP1/AO servers. |
Optional |
1.6 Procedure to enable HTTPS connections between Web browsers and JP1/AO |
9 |
Enable SSH connections with operation target devices. |
Optional |