1.3.1 Procedure to perform a new installation of JP1/AO

You can perform a new installation of JP1/AO from the Hitachi Integrated Installer, as prompted by the wizard.

Before you begin

Perform all of the tasks that are required prior to installing JP1/AO, such as checking prerequisites and installing JP1/Base.

To perform a new installation of JP1/AO:

1. Insert the distribution medium into the drive and run the Hitachi Integrated Installer.

2. Continue the configuration process as prompted by the wizard.

   • Specify the JP1/AO installation folder.

   • Specify the JP1 users to link to JP1/Base and JP1/AJS3.

3. Check the summary that is displayed to verify the settings that you have entered in the wizard thus far.

   If necessary, you can click the Edit settings button and change the following items:

   • Installation folders for the databases

   • IP address or host name of the JP1/AO server

   • Port number of the JP1/AO server

   • Backup execution flag and backup folder

     Setting the backup execution flag and backup folder is required only if the Hitachi Command Suite product is installed.

4. Click the Install button to start the installation of JP1/AO.

   When the installation of JP1/AO is complete, the JP1/AO - Contents installation wizard is displayed.

5. Specify the JP1/AO - Contents installation folder.

6. Check the summary that is displayed to verify the settings that you have entered in the wizard thus far.

7. Click the Install button to start the installation of JP1/AO - Contents.

8. If you entered a value other than the default port number, perform the procedure to change the port number.

9. After the installation is complete, execute the hcmdssrv command with the /start option specified to start the JP1/AO service.

Tip

By specifying JP1 users during installation, you will be able to authenticate users by using JP1/Base functions. JP1 user information that has already been registered can be changed from Service Share Properties in JP1/AO.

Important note

• If you interrupt the installation process, it might leave empty folders. You can manually delete any empty folders that were created.

• If Common Component fails to install and you have to reinstall, you cannot specify an installation destination that is different from the previous destination. Even if you enter a different destination, it will automatically be installed in the previous installation destination.

Results of procedure

• The product names listed below are displayed in the Programs and Features window displayed by clicking Windows Control Panel, Programs and then Programs and Features.

  Table 1‒3: Product names displayed in the Programs and Features window

  Product name	Version
  JP1/Automatic Operation	vv.rr.mm
  JP1/Automatic Operation - Contents	vv.rr.mm

• JP1_Automatic Operation is added under All Programs in the Start menu.

• Some ports used for internal connections in JP1/AO are registered as firewall exceptions.

Related topics

• 1.1 New installation procedure

• 1.2 Pre-installation tasks

• 1.3.2 Installation folder for each product

• 1.3.3 Installation folders for databases

• 1.3.4 Database backup folder

• 4.6.1 Procedure to change the port number used for communications between JP1/AO and Web browsers

• JP1/AO services in the Job Management Partner 1/Automatic Operation Administration Guide

• List of shared built-in service properties in the Job Management Partner 1/Automatic Operation Administration Guide

• Ports used for JP1/AO internal connections in the Job Management Partner 1/Automatic Operation Overview and System Design Guide

To Page Top