Job Management Partner 1/Software Distribution Setup Guide

[Contents][Glossary][Index][Back][Next]

2.1.24 Setting up the OpenView gateway server

To use the OpenView Linkage facility to establish connection to JP1/Software Distribution Manager from HP NNM version 7.5 or earlier, you must install OpenView Gateway Server on the JP1/Software Distribution Manager PC. This subsection describes the setting that is required in order to install OpenView Gateway Server.

Organization of this subsection
(1) Port Number to Connect OpenView Linkage

(1) Port Number to Connect OpenView Linkage

Specify the port number used by the OpenView Gateway Server to establish connection with OpenView Linkage.

You can change this setting during setup.

Figure 2-31 Port Number to Connect OpenView Linkage dialog box

[Figure]

For Port number, specify the port number that has been specified in the Port Number to Connect OpenView Gateway Server dialog box during installation of OpenView Linkage. The default is 20049.

[Contents][Back][Next]

[Trademarks]

All Rights Reserved. Copyright (C) 2009, 2013, Hitachi, Ltd.
Copyright, patent, trademark, and other intellectual property rights related to the "TMEng.dll" file are owned exclusively by Trend Micro Incorporated.