Job Management Partner 1/Base User's Guide
In a JP1/Base system with a secondary authentication server, if connection to the primary authentication server fails, JP1/Base will use the secondary authentication server instead, blocking access to the primary authentication server. This section describes how to check and release the blocked status, and how to place an authentication server in the blocked status.
- Note
- You cannot check, release, or set the blocked status if there is only one authentication server. The blocked status applies only in a JP1/Base system with two authentication servers in one user authentication block.
In the Windows version of JP1/Base, you can use the GUI or commands to work with blocked status settings. In the UNIX version, you use commands.
- Organization of this section
- 6.4.1 Blocked status settings using the GUI (Windows only)
- 6.4.2 Blocked status settings using commands
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.