Job Management Partner 1/Base User's Guide

6.4.2 Blocked status settings using commands

The following explains how to use commands to work with the blocked status. Here we assume that the system administrator specified server1 as the primary authentication server and server2 as the secondary authentication server.

Organization of this subsection

(1) Checking the blocked status

(2) Releasing the blocked status

(3) Placing an authentication server in the blocked status

(1) Checking the blocked status

To check whether an authentication server is blocked, execute the following command:
jbslistsrv 
 
For details on the jbslistsrv command, see jbslistsrv in 13. Commands.

(2) Releasing the blocked status

To release an authentication server from the blocked status, execute the following command:
jbsunblockadesrv -s authentication-server
 
For details on the jbsunblockadesrv command, see jbsunblockadesrv in 13. Commands.

(3) Placing an authentication server in the blocked status

To place an authentication server in the blocked status, execute the following command:
jbsblockadesrv -s authentication-server
 
For details on the jbsblockadesrv command, see jbsblockadesrv in 13. Commands.

[Contents][Back][Next]

[Trademarks]