Job Management Partner 1/Base User's Guide
Note the following when setting up user management:
When you set user management in a cluster system, you must first set up the environment for a cluster system as described in 3. Setting Up JP1/Base for Use in a Cluster System. Then, set up user management as described in 6.3 User management setup (in UNIX). When setting user management, specify a logical host name for the -h option in each command.
When you operate an authentication server in a cluster system, the setting files for the authentication server are stored in the following directory:
shared-directory-name/jp1base/conf/user_acl/
If you are using a secondary authentication server, you must copy the settings files from the primary authentication server to the secondary authentication server. Note that the copy destination varies depending on whether you use the secondary authentication server in a cluster system:
- When using a cluster system:
- shared-directory-name/jp1base/conf/user_acl/
- When not using a cluster system:
- /etc/opt/jp1base/conf/user_acl/
After copying the settings files, execute the following command to apply the settings. You need to specify the -h option only if you use the secondary authentication server in a cluster system:
jbs_spmd_reload -h logical-host-name
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.