Job Management Partner 1/Base User's Guide

6.3 User management setup (in UNIX)

This section describes the user management setup required in UNIX. If you performed automatic setup when installing JP1/Base, the default value has been set. For details on the default of automatic setup, see 2.3.1 Installing JP1/Base.

The setup method differs depending on whether the host is to be used as an authentication server.

If you use the secondary authentication server, setting information for both the primary authentication server and the secondary authentication server must be the same. The following figure shows the setup procedure required on each host and the corresponding sections in this manual.

Figure 6-12 User management setup procedure (in UNIX)

Organization of this section

6.3.1 Specifying the authentication servers to use

6.3.2 Setting JP1 users

6.3.3 Setting JP1 user operating permissions

6.3.4 Copying settings from the primary authentication server

6.3.5 Setting user mapping

6.3.6 Notes on user management setup

[Contents][Back][Next]

[Trademarks]