Job Management Partner 1/Base User's Guide

[Contents][Glossary][Index][Back][Next]

2.3.1 Installing JP1/Base

To install JP1/Base:

  1. Quit all programs.
    Be sure to quit all JP1 programs, and all programs that are currently accessing the JP1/Base event service, before you install JP1/Base.

  2. Run the Hitachi Program Product Installer.
    Install JP1/Base as prompted by the Hitachi Program Product Installer. For the operation steps, see 2.3.2 Using the Hitachi Program Product Installer.
    For a new installation, the Installer sets up and initializes JP1/Base automatically so that JP1/Base is ready for operation immediately after installation completes.
    The following items are set when you select automatic setup:

    Table 2-2 User management defaults

    Item Contents
    Authentication server settings Authentication server name Local host name
    JP1 user settings JP1 user name jp1admin
    Password jp1admin
    JP1 resource group *
    Granted permissions JP1_AJS_Admin, JP1_JPQ_Admin, JP1_AJSCF_Admin, JP1_PFM_Admin, JP1_Console_Admin, JP1_CM_Admin, JP1_Rule_Admin, JP1_Audit_Admin, JP1_DM_Admin
    User mapping settings JP1 user name to be mapped jp1admin
    Name of the server host where the JP1 user issues operating instruction *
    Mapping between the JP1 user and OS user The JP1 user (jp1admin) is mapped to an OS user (root) registered with each host.
    For details on each item, see 6.3 User management setup (in UNIX).
    At execution, the Hitachi Program Products Installer automatically installs the Hitachi Network Objectplaza Trace Library (HNTRLib2). The installation folder is /opt/hitachi/HNTRLib2/.

Remote installation of JP1/Base (software deployment) through JP1/Software Distribution:
JP1/Base supports remote installation through JP1/Software Distribution. JP1/Base allows you to perform the following types of installation:
  • Installation of a new program
    You can install a new JP1/Base program in the target host. Remote installation using JP1/Software Distribution does not support automatic setup.
  • Upgrade to a newer version
    You can upgrade an existing JP1/Base program to a newer version on the target host through remote installation.
For details on how to perform an actual remote installation by using JP1/Software Distribution, see the manual Job Management Partner 1/Software Distribution Manager Description and Administrator's Guide, Job Management Partner 1/Software Distribution SubManager Description and Administrator's Guide (for UNIX systems), and Job Management Partner 1/Software Distribution Client Description and User's Guide (for UNIX systems).

[Contents][Back][Next]

[Trademarks]

All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.