Job Management Partner 1/Base User's Guide

2.3.2 Using the Hitachi Program Product Installer

The Hitachi Program Product Installer is stored on the medium supplied with JP1/Base. This section describes the following operations:

Starting the Hitachi Program Product Installer

Installing JP1/Base with the Hitachi Program Product Installer

Deleting JP1/Base with the Hitachi Program Product Installer

Checking the version of installed Hitachi program products with the Hitachi Program Product Installer

Notes on using the Hitachi Program Product Installer

Superuser permissions are required to use the Hitachi Program Product Installer. Log in as the superuser, or execute the su command to change your user account to the superuser.

Organization of this subsection

(1) Starting the Hitachi Program Product Installer

(2) Installing JP1/Base

(3) Deleting JP1/Base

(4) Displaying version information

(1) Starting the Hitachi Program Product Installer

To install JP1/Base from the supplied magnetic tape:

Mount the JP1/Base tape in the tape unit.

Execute the following command to extract the Hitachi Program Product Installer:
tar xf device-file-name

Execute the following command to start the Hitachi Program Product Installer:
/etc/hitachi_setup -i device-file-name

To install JP1/Base from the supplied CD-ROM:

Insert the JP1/Base CD-ROM into the drive.

Mount the CD-ROM drive.
Execute the command as follows: The command that you can use differs according to your OS. This step is unnecessary for a Solaris system.
Command for HP-UX: /usr/sbin/mount -F cdfs -r device-special-file-name/cdrom
Command for AIX: /usr/sbin/mount -r -v cdrfs /dev/cd0 /cdrom
Note: The words in italics differ depending on your operating environment.

Execute the following command to install and start the Hitachi Program Product Installer:
/cdrom/XXXX/setup /cdrom
XXXX differs depending on your operating environment.
For an HP-UX system, change setup to upper-case SETUP. For Solaris, the CD-ROM drive is mounted automatically. Specify the device special file name for the automatically mounted drive for device-special-file-name/cdrom.

(2) Installing JP1/Base

The following explains how to install JP1/Base with the Hitachi Program Product Installer. The initial window appears when you start the Installer. An example is shown in the following figure.

Figure 2-2 Example of the Hitachi Program Product Installer initial window

Enter I in this window to see a list of the software that you can install. Move the cursor to JP1/Base, then press the space bar to select that item. Enter I again to install JP1/Base. When you finish the installation, enter Q to return to the initial window.

(3) Deleting JP1/Base

Execute the following command to start the Hitachi Program Product Installer:
/etc/hitachi_setup 
The initial Installer window appears. For an example, see Figure 2-2.

Enter D in this window to see a list of the installed software that can be deleted. Move the cursor to JP1/Base, then press the space bar to select that item. Enter D again to delete JP1/Base. When you finish deleting software, enter Q to return to the initial window.

(4) Displaying version information

Execute the following command to start the Hitachi Program Product Installer:
/etc/hitachi_setup 
The initial Installer window appears. For an example, see Figure 2-2.

Enter L in this window to see a list of the installed Hitachi program products.

[Contents][Back][Next]

[Trademarks]