Job Management Partner 1/Integrated Management - Manager Quick Reference
To map the JP1 user account with which commands are executed to an OS user account on a host, you use JP1/Base user mapping. Once user mapping is configured, from a management server, you can execute commands or perform automated actions on a target host in the product planning department or the sales department. For details about how to configure automated actions, see 3.2.1 Using the automated action function to execute a command.
The following subsections separately explain how to configure user mapping by using a graphical user interface (GUI) and by using a command.
- Prerequisite condition:
- Refer to the chapter that describes how to set up user mapping in the Job Management Partner 1/Base User's Guide, and make sure all of the prerequisite conditions are met.
The following subsections explain how to map the JP1 user account used to execute commands (jp1admin) to an OS user account (salesA). Note that user mapping has to be configured for each host.
- Organization of this subsection
- (1) Using the GUI
- (2) Using a command
(1) Using the GUI
Using the GUI, you configure user mappings in the User Mapping page of the JP1/Base Environment Settings dialog box.
- To display the window:
- To open the JP1/Base Environment Settings dialog box, from the Start menu, choose Programs, JP1_Base, and then Environment Settings.
- Reference:
- Chapter on setting up user mapping in the Job Management Partner 1/Base User's Guide
(2) Using a command
You use jbssetumap to set up user mapping. Execute the command as shown below:
jbssetumap -u jp1admin -sh admin -o salesA
- References:
- Chapter on setting up user mapping in the Job Management Partner 1/Base User's Guide
- Section on the jbssetumap command in the Job Management Partner 1/Base User's Guide
All Rights Reserved. Copyright (C) 2009, Hitachi, Ltd.