16.21.1 Normally terminating and then swapping the HADB server in a multi-node configuration
The following shows the procedure for normally terminating the HADB server and then swapping it with its revised version in a multi-node configuration:
Procedure:
-
Normally terminate the HADB server in a multi-node configuration
For details about the procedure for terminating the HADB server normally in a multi-node configuration, see (a) Normally terminating HADB servers in the multi-node configuration in (1) Termination procedures for HADB servers in a multi-node configuration under 16.4.2 Terminating HADB servers in the multi-node configuration.
-
Swapping of the HADB server with its revised version on all nodes
For details about how to swap the HADB server with a revised version, see 8.8 Swapping the HADB server with its revised version.
-
Normally start the multi-node configuration HADB server
For details about the procedure for starting the HADB server normally in a multi-node configuration, see (1) Startup procedure for the HADB servers in a multi-node configuration in 16.4.1 Starting the HADB servers in the multi-node configuration.