12.5 Troubleshooting the audit trail facility
This section describes the steps to take if a problem occurs in relation to the audit trail facility.
If an error occurs when outputting audit trails, the KFAA51404-E message is output. The action you need to take depends on the value of the variable aa....aa in the KFAA51404-E message.
-
If the variable aa....aa is The audit trail file disk is full
See 12.5.1 Steps to take when the disk containing the audit trail directory is full.
-
If the variable aa....aa is errno cc....cc
See 12.5.2 Steps to take when a failure occurs in the disk containing the audit trail directory.
-
If the variable aa....aa is The audit trail file could not be opened, because file descriptors were insufficient
See 12.5.3 Steps to take when there are insufficient file descriptors.
For details about the KFAA51404-E message, see the manual HADB Messages.